[1]贾峰,刘荣,杨铭.盐酸直接浸出高钛型高炉渣[J].南京师范大学学报(工程技术版),2012,12(02):043-49.
 Jia Feng,Liu Rong,Yang Ming,et al.Leaching of High-Ti-Bearing Blast-Furnace Slag Directly in Hydrochloric Acid[J].Journal of Nanjing Normal University(Engineering and Technology),2012,12(02):043-49.
点击复制

盐酸直接浸出高钛型高炉渣
分享到:

南京师范大学学报(工程技术版)[ISSN:1006-6977/CN:61-1281/TN]

卷:
12卷
期数:
2012年02期
页码:
043-49
栏目:
出版日期:
2012-06-20

文章信息/Info

Title:
Leaching of High-Ti-Bearing Blast-Furnace Slag Directly in Hydrochloric Acid
作者:
贾峰1刘荣12杨铭3
( 1. 南京师范大学能源与机械工程学院,江苏南京210042) ( 2. 南京师范大学地理科学学院,江苏南京210046) ( 3. 南京工程学院机械工程学院,江苏南京211167)
Author(s):
Jia Feng1Liu Rong12Yang Ming3
1.School of Energy and Mechanical Engineering,Nanjing Normal University,Nanjing 210042,China
关键词:
高钛型高炉渣盐酸浸出酸浸渣正交试验法
Keywords:
Ti-bearing blast-furnace slaghydrochloric acid leaching acid leaching residue orthogonal test method
分类号:
X758
摘要:
基于TiO2不易溶于盐酸,采用盐酸在不同条件下直接浸出高钛型高炉渣,分析了不同的原料粒度、加热温度、酸渣比、盐酸浓度和反应时间对酸浸渣中TiO2含量及物相组成的影响,并使用正交试验方法找出最佳反应条件及影响因素的顺序.研究结果表明:在原料粒度120~180μm,加热温度95℃,酸渣比1.5∶1,盐酸浓度8 mol/L,反应时间4h条件下,Mg、Fe、Al等元素酸解充分,获得TiO2含量超过45%的酸浸渣,经表征分析浸出渣中钛主要以钙钛矿(CaTiO3)和偏钛酸(H2TiO3)结构形式出现.由于钙钛矿反应活性差和透辉石酸解生成硅酸胶体覆盖在炉渣表面,4 h以后TiO2含量没有明显变化,分析高钛型高炉渣中各物相的浸出速率由快到慢依次为:尖晶石、透辉石、钙钛矿.
Abstract:
Based on the reactive differences of titan and other elements to hydrochloric acid, the Ti-bearing blast-furnace slag was leached directly with hydrochloric acid in different conditions. The effect of the particle size,heating temperature, the ratio of acid and slag,hydrochloric acid concentration and reactive time on the mass fraction of acid leaching slag were analyzed. Moreover,Orthogonal Test Method was used to identify the optimal reaction conditions and the order of influencing factor. The experimental results show that Mg、Fe、Al were acid-splitting entirely,and the acid leaching residue can be obtained with over 45% TiO2 at the conditions that the particle size is of 120 ~ 180 μm,heating temperature is of 95℃, the ratio of acid and slag is of 1. 5∶ 1,hydrochloric acid concentration is of 8 mol /L and reactive time is of 4 h, the titania mainly consists in unreacted CaTiO3 and H2TiO3 by representational analysis. After four hours, the percentage of TiO2 showed no significant changes due to lower reactivity of the perovskite and the coverage of silicic acid from the acidolysis of diopside. The dissolution rate of differently phase compositions in slag descended in the following order of spinel diopside and perovskite.

参考文献/References:

[1]李大成,刘恒,周大利. 钛冶炼工艺[M]. 北京: 化学工业出版社, 2009: 11-15. Li Dacheng,Liu Heng,Zhou Dali. Titanium Smelting Process[M]. Beijing: Chemical Industry Press, 2009: 11-15. ( in Chinese)
[2]李兴华,蒲江涛. 攀枝花高钛型高炉渣综合利用研究最新进展[J]. 钢铁钒钛, 2011, 32( 2) : 10-14. Li Xinghua,Pu Jiangtao. The latest developments of integrated utilization on panzhihua high titanium-bearing BF slag[J]. Iron Steel Vanadium Titanium, 2011, 32( 2) : 10-14. ( in Chinese)
[3]刘松利,张雪峰. 攀枝花高钛型高炉渣综合利用的进展与展望[J]. 攀枝花技术与信息, 2010, 35( 3) : 1-4. Liu Songli,Zhang Xuefeng. Panzhihua high titanium blast furnace slag comprehensive utilization progress and prospect[J]. Panzhihua Sci-Tech and Information, 2010, 35( 3) : 1-4. ( in Chinese)
[4]隋智通,郭振中,张力,等. 含钛高炉渣中钛组分的绿色分离技术[J]. 材料与冶金学报, 2006,5 ( 2) : 93-97. Sui Zhitong,Guo Zhenzhong,Zhang Li,et al. Green separation technique of Ti component from Ti-bearing blast-furnace slag [J]. Journal of Materials and Metallurgy, 2006,5 ( 2) : 93-97. ( in Chinese)
[5]攀钢集团研究院有限公司. 碳化渣低温选择性氯化制备TiCl4 工艺及装备研究[C]/ / 攀枝花: 高钛型高炉渣综合利用学术研讨会论文集, 2010: 11-23. Pangang Group Research Institute Co. ,Ltd. . Reasarch on process and equipments of selective chlorination of carbonized Pangang BF slag[C]/ / Panzhihua: Papers of the 2010’s Conference on Integrated Utilization on Panzhihua High Titanium-bearing BF Slag, 2010: 11-23. ( in Chinese)
[6]侯世喜,柯昌明,李有奇,等. 金属热还原含钛高炉渣制取合金及残渣的研究[J]. 铁合金, 2007( 5) : 20-23. Hou Shixi,Ke Changming,Li Youqi, et al. Preparation alloy and residue from titanium-bearing blast furnace slag of metal othermic reduction[J]. Ferro-Alloys, 2007( 5) : 20-23. ( in Chinese)
[7]柯昌明,韩兵强,魏耀武,等. 高钛型高炉渣等离子熔融还原法提钛研究[C]/ / 攀枝花: 高钛型高炉渣综合利用学术研讨会论文集, 2010: 43-48. Ke Changming,Han Bingqiang,Wei Yaowu, et al. Extracting titanium by plasma smelting reduction from high titanium-bearing BF slag[C]/ / Panzhihua: Conference on Integrated Utilization on Panzhihua High Titanium-bearing BF Slag, 2010: 43-48. ( in Chinese)
[8]刘晓华,隋智通. 含钛高炉渣酸解动力学[J]. 金属学报, 2003, 39( 3) : 293-296. Liu Xiaohua,Sui Zhitong. Kinetics of leaching Ti-bearing slag by dilute sulphuric acid[J]. Acta Metallurgica Sinica, 2003, 39 ( 3) : 293-296. ( in Chinese)
[9]王明华,都兴红,隋智通. H2 SO4 分解富钛精矿的反应动力学[J]. 中国有色金属学报, 2001, 11( 1) : 131-134. Wang Minghua,Du Xinghong,Sui Zhitong. Kinetics of acidolysis of rich titanium concentrate by H2 SO4 [J]. The Chinese Journal of Nonferrous Metals, 2001, 11( 1) : 131-134. ( in Chinese)
[10]马光强,邹敏,张云,等. 含钛高炉渣制备钛渣的工艺研究[J]. 稀有金属, 2010, 34( 3) : 467-470. Ma Guangqiang,Zou Min,Zhang Yun, et al. Preparation of Ti-enriched slag from Ti-bearing blast-furnace slag[J]. Chinese Journal of Raremetals, 2010, 34( 3) : 467-470. ( in Chinese)
[11]王曾洁,张利华,王海北,等. 盐酸常压直接浸出攀西地区钛铁矿制备人造金红石[J]. 有色金属,2007,59 ( 4) : 108-111. Wang Zengjie,Zhang Lihua,Wang Haibei, et al. Ilmenite hydrochloric acid leaching for synthetic rutile preparation[J]. Nonferrous Metals, 2007, 59( 4) : 108-111. ( in Chinese)
[12]霍红英,刘国钦,邹敏,等. 非水淬高钛型高炉渣的综合利用研究[J]. 湿法冶金, 2010, 29( 1) : 44-48. Huo Hongying,Liu Guoqin,Zou Min, et al. Studies on comprehensive utilization of air-cooled high ti-bearing blast-furnace slag [J]. Hydrometallurgy of China, 2010, 29( 1) : 44-48. ( in Chinese)
[13]王海舟. 炉渣分析[M]. 北京: 科学出版社, 2006: 51-191. Wang Haizhou. Slag Analysis[M]. Beijing: Science Press, 2006: 51-191. ( in Chinese)
[14]方开泰. 正交与均匀试验设计[M]. 北京: 科学出版社, 2001: 35-56. Fang Kaitai. Orthogonal and Uniform Test Design[M]. Beijing: Science Press, 2001: 35-56. ( in Chinese)
[15]吴本羡. 攀枝花钒钛磁铁矿工艺矿物学[M]. 成都: 四川科学技术出版社, 1998: 151-166. Wu Benxian. Panzhihua Vanadium Titanium Magnetite Processing Mineralogy[M]. Chengdu: Sichuan Science and Technology Press, 1998: 151-166. ( in Chinese)

备注/Memo

备注/Memo:
基金项目: 江苏省2011 年度普通高校研究生科研创新计划( CXLX11_0888) .通讯联系人: 刘荣,博士,副教授,研究方向: 环境材料制备及加工工艺. E-mail: liurongle@163. com
更新日期/Last Update: 2013-03-11